Go to the first, previous, next, last section, table of contents.
- Computer:
-
A4000 Hardital Power Changer 040 at 28Mhz, 2MB chip, 16MB fast.
8088 bridgboard (No laughing, it was free ;-) ), Mitsumi FX002D + Tandem.
- Hostadapter:
-
MakroSystems Hardcard with Fujitsu ~40MB HD evolution.device
- CD writer:
-
YAMAHA CDR400t 1.0c (12/03/97)
- Jumpers:
-
Termination: on (Jumper off)
Parity: off (Jumper on)
Unit: 3
Block Size: 2048 (Jumper off)
- Driver:
-
MMC V7.8 (this driver is named now CDR_SCSI3_ATAPI)
- Comments:
-
Took a while to get working due to lack of docs, i.e. transport info and
nothing else! Thanx Yamaha! This drive is an excellent piece of kit.
646mb Data track at 4x speed in 17mins! No problems encountered. Seems to
enjoy any writable CD's up till now, very easy to feed ;-).
- CD-ROM drive:
-
PIONEER CD-ROM DR-U10X 1.07 ( 1996/08)
- Jumpers:
-
Termination: off (Jumper on)
Unit: 2
Block Size: 2048 (Jumper off)
- Driver:
-
PlextorCD V7.4
- Comments:
-
Nice 10x CDROM, works perfectly but doesn't like CD's with sticky labels
(low clearance in drive). Reads CDDA.
- Hard disk:
-
Seagate ST3144A 130 MB HD as boot drive.
- Comments:
-
Got nowhere with this. MakeCD always reported Cmd Error $52, Drive not
ready. Tried all possible settings.
- Tips:
-
May be better in a Museum!
Tested by Glenn Mrosek <Gremlin@I-Memory.dontpanic.sub.org>, +49 571 508316.
Go to the first, previous, next, last section, table of contents.