GAME: CYBERRACE
FORMAT: FLOPPY DISK
PUBISHER: CYBER DREAMS
TEL: 081 343 4818   

CyberRace must be installed to hard disk before it will run.

CyberRace will not run from protected mode, so you will need to remove 
memory managers and so on from your CONFIG.SYS and AUTOEXEC.BAT files.
Alternatively, after installing the game to hard drive, type CRBOOT from 
the CYBERACE directory to create a boot floppy disk. Ensure you have a
floppy disk in the drive before tying CRBOOT. By creating the boot disk 
you will lose all information previously stored on the floppy disk.

* Recently, a number of sound card manufacturers have changed their default
  IRQ setting from 7 to 5.  This was done to prevent various hardware conflicts
  with third party devices, which can cause some software to lock 
  intermitently. If you experience any problems, particularly sound related,  
  while playing CyberRace, try adjusting your sound card to run at a lower 
  IRQ setting. Follow your sound card's directions or contact the 
  manufacturer's technical support to reconfigure your card to run at a lower 
  interupt number.  We recommend running at an IRQ of 5, and a DMA of 1.

* If you are using a sound card other than SoundBlaster and the boot disk, 
  you must add to the corresponding files on your boot disk the sound card
  configuration information from your CONFIG.SYS and AUTOEXEC.BAT. 

* The Num Lock must be off in order for the keypad controls to function.

* If you use a ThrustMaster input device connected to a sound card game
  port, the "Hat" controls may not function properly.  In such cases, 
  we advise you to connect your ThrustMaster to a separate game port.


Press Esc to exit the demo