The Guitar Teacher Tuner: To sound the selected string, press the button with the quarter note on the button's face. To stop the sound, press the button with the quarter rest on its face. Selecting a new string starts the sound automatically. Any time a new frequency begins to sound, it will last up to 60 seconds if the tuner is left untouched. To restart the sound, press the quarter-note button. Tuning: If you have trouble tuning your guitar, you're in good company. Most people including many professionals have a love/hate relationship with their instruments because of tuning problems. In most cases, it's because the guitar was not set up right in the first place, and is actually impossible to tune correctly. But, even if everyone was given a perfectly adjusted instrument, it's doubtful that one in a great number could properly explain how to tune it. Many know various ways of getting the instrument into some kind of acceptable shape, but most methods are faulty. The most common method of tuning is actually a very poor one. Most guitarists learn early that the first string open (E, the thinnest string) is the same pitch as the second string at the fifth fret. One starts by hoping that the first string is close to being in tune, and then if the second string, fifth fret can be tuned to sound the same as the first string open, then the second string it is reasoned must be in tune as well. After comparing the second string with the first, the third string is compared with the second and so on until all of the strings are in tune. There are at least two problems with this method. First of all, most guitars, especially acoustics, don't have their bridge "saddles" set at the right distance from the top nut, so when the second string was played at the fifth fret, it probably wasn't perfectly in tune and therefore not a good reference. Secondly, our hearing is not perfect and even when we think two notes are perfectly in tune there is still a certain amount of error. As you move across the neck toward the sixth string, your error is compounded. How many times have you used this method, thinking you did a good tuning job and then when you played a chord it sounded terrible? That's because when you tuned the second string to the first, you were just a little out, but by the time you got to the sixth string, you were a long way out. When tuning, it's best if you tune every string to the same note instead of several different notes that get gradually more and more out of tune. This can be a little tricky and demands considerably more knowledge. However, with the Guitar Teacher tuner you don't have to worry about the problems of tuning to inaccurate notes. Also, you're not tuning the strings at the fifth or any other fret--you tune them as open strings. So how does one know when the string is actually in tune with the tone from the computer? Most people can tune it so it's close, but there's a way to be very precise. When two notes are close to the same pitch, but not quite, you should hear a faint pulsating sound. As the notes get closer to being the same pitch the pulsating slows down, and the goal is to make it stop altogether. When it stops, the two notes are vibrating at the same number of cycles per second (Hertz or Hz). If you find that later, a string seems to have gone out of tune, go back to the tuner. Tuning to another string which itself might be a little out is where you begin getting the whole thing in a mess again. If your tuning still seems inaccurate, it may be that your bridge and/or top nut are not adjusted properly (this is a common problem). You might consider taking your guitar to a repair shop for an opinion.