Image Info V1.1

This is a new version of IMGINFO.ACC uploaded as file  #8819.   
It is not a fix of version 1.  From what I can tell (no negative 
responses as of yet), version 1 seems to work.  Version 1.1 changes 
the basic functionality.  Specifically:

     *  It retrieves more information than version 1.  It provides
        the image size in pixels (as before).  It also uses the scan
        information in the IMG file to determine the size of the 
        original art work in inches.  It then takes information on 
        the resolution of your output device, and calculates what I
        call the optimal image size (where there will be a one to one
        pixel mapping from the image onto the device).  This version
        assumes a 9 pin printer with a driver supporting a 120 x 144
        dots per inch output.  (see note below).

     *  It will gracefully handle a premature end of file condition
        if the IMG file it read comes up short of the required 16 byte
        header.

     *  It also preserves the drive and path specified between multiple
        uses of the accessory.  Version 1 would reset this information
        between uses.

And that's about it.  Version 1.1 was also written in Personal Pascal 
and free to anyone who appreciates it.  Any comments, questions or
suggestions are welcome.

Jim Williams

(Note:  My original intent was to include in this version functionality
 which would allow a user to specify the resolution of their output 
 device and then save that information in the executable image of the 
 accessory.  Alas, after hours of fiddling, using Dan Wilga's Memfile
 2.0 (which I find a most pleasant dump utility) I was unable to 
 find all the information which I would have to change.  The next 
 version, if there's any demand for it, will provide that functionality.  
 For now, I really should be studying for the GRE this Saturday.)