TAPR TNC 2 Software Release Notes ............ Release 1.1.0

1)   The  correct sign-on message for this release of TNC  2 
     software is:

     Tucson Amateur Packet Radio TNC 2
     AX.25 Level 2 Version 2.0
     Copyright (c) 1985 Systek. All rights reserved.
     Release 1.1.0
     Checksum $C8
     cmd:

2)   A new message

     ?not while connected

     appears  if you attempt to alter your callsign (MYCALL) 
     or change the AX.25 Level Two Version number  (AX25L2V2 
     ON|OFF) while TNC 2 is not in the disconnected state.

3)   The  text  messages  stored in BTEXT and CTEXT  may  be 
     cleared by entering a % or & as the first letter in the 
     text.  Fort example, to clear the beacon text, enter

     BTEXT %<cr>

     and the BTEXT buffer will be cleared.

4)   Unlike  TNC  1,  the message in BTEXT (and  CTEXT)  are 
     stored in battery-backed RAM (bbRAM).

5)   THINK TWICE BEFORE USING THE RESET COMMAND!  Unlike TNC 
     1, RESET on TNC 2 changes ALL parameters to their de-
     fault values!

6)      TNC 2 SOFTWARE SOURCE CODE and TNC FIRMWARE
                     Copyright (c) 1985
                           Systek
                    All rights reserved.

     Reproduction  or translation of any part of  this  work 
     beyond  that  permitted by Sections 107 or 108  of  the 
     1976  United States Copyright Act (or its legal succes-
     sor)  without the express permission of  the  copyright 
     owner is unlawful except as noted below.   Requests for 
     permission to copy or for further information should be 
     addressed to:

                Tucson Amateur Packet Radio
                        PO Box 22888
                   Tucson AZ  85734-2888
                    ATTN TNC 2 SOFTWARE