Here is how to get non capital tones on a Roland SCXXX Sound Module thrugh
Cakewalk for Windows.

Go to a point in the song where you want the sound to start.

click right button, select event list.

insert three events....Just press the insert key on keyboard 3 times)

change first event to CONTROL
  change first value to 0 second value to cco# from sound chart
change second event to PATCH CHANGE  
  change value to pc# from sound chart
change third even to CONTROL
  change first value to 0 change second value to 0

remember that scc-1 pc#(patch nums) are 1 greater than cakewalk nums
so if you wanted to change the sound to scream the event list would
look like this:

track time      ch    kind   values
 2    1:1:000   6     cntrl  0 2
 2    1:1:001   6     patch  126
 2    1:1:002   6     cntrl  0 0



Done there you go....but remember that these are 'embedded' events in your
song, like a note....note events are like pressing a keyboard key, and patch
change/control events are like me pushing buttons on my canvas to change a 
sound----moral of story is again that these things ONLY occur as the song is
being played so it can get confusing when you have one patch listed on the 
track view of cakewalk and embedded sounds in the song and it doesn't sound 
when you want it too.




written by Randy Wolf: rwolf@etsun.tech.iupui.edu
		       IKPR500@INDYVAX.IUPUI.EDU

Mike
mtressle@bsu-cs.bsu.edu