File Copy
                                   ---------
                                 Version 1.01a
                                ½Carl J. Hafner
                             -------------------- 
                              ALL RIGHTS RESERVED
                             --------------------
                               Revised: 3/08/94

    DISCLAIMER
    ----------
    The author cannot be responsible for any damage to your equipment,
    other software or hardware products or physical or mental well being
    caused by the use, misuse, abuse or inability to use this program.

    The author also makes no guarantee as to the compatibility of this 
    program with other software or hardware products.

    Using this program means that you understand AND agree with the
    terms just explained. If you do not understand AND agree, DO NOT
    use this program.


    INSTANT GRATIFICATION
    ---------------------
    After reading over FILECOPY.TXT I realized that it goes into ALOT of
    detail, perhaps more than is necessary (nahhh ;-). This file is 
    intended to get you going quickly on a _BASIC_ level.

 o  Load the program.

 o  Select a SOURCE drive letter (for the fileselector), A-P.

 o  Select a DESTINATION drive letter (for the fileselector), A-P.

 o  Click on the name "Source Directory". When the fileselector appears,
    open a folder and click on OKAY in the fileselector. The line should
    then look like... A:\FOLDER\ .

 o  Repeat this for selecting a destination folder (if the preset is not to
    your liking). The line should look like...  B:\FOLDER\ .

 o  Enter a SETUP NAME and any COMMENTS.

 o  Select the SET button (or click on an arrow) to save this setup in memory.

 o  Select the SAVE button to save either an  SBL , SBE  or  CNF  file.
    Select the LOAD button to load a SAVED  SBL  or  SBE  file.

 o  Select the COPY button to copy the contents of  A:\FOLDER\  to
    B:\FOLDER\ .

 o  THAT'S _BASICALLY_ IT !

 o  NOTE: FOLDER names MUST end with a backslash " \ "  or FileCopy will
          think it's a FILE.

    To understand the details of what's happening and why, read
    FILECOPY.TXT .


    OVERVIEW OF ADDITIONAL FUNCTIONS
    --------------------------------
 o  The arrows to the right of the SETUP NAME are for scrolling through
    your library. 

 o  The DISPLAY button toggles the STATUS DISPLAY on and off.

 o  The ALERTS button activates warning alerts.

 o  The EXPERT button allows you to copy  SBL  files with minimum input.
 
 o  The FILE button allows access to extended file functions.

 o  The SORT button allows sorting of library files (read FILECOPY.TXT
    before using !)

 o  The SET button saves the current setup in memory.