S3 OS/2 2.1 and 3.0 Driver
   This section describes S3 OS/2 driver and installation instructions.
A. Installation Considerations
1. You must know the maximum vertical refresh rate as well as the maximum resolution supported by the monitor.
2. When installing the S3 driver to replace a non-S3 driver (e.g., SVGA), the standard IBM VGA driver must be installed first. This is not required if you are replacing an S3 driver.
3. If you are copying the driver onto blank diskettes, you must label the diskettes correctly. The first driver diskette must be labeled S3 DRV1. The second driver diskette must be labeled S3 DRV2.
4. An S3 chip-based card must be installed in the computer before you install the driver. (The driver reads information from the accelerator chip.)

B. Installation Instructions
   The OS/2 setup program installs and modifies all of the necessary files. Follow these steps to install the OS/2 driver.
1. Boot up OS/2 in the VGA mode.
2. Save all open data files before continuing the S3 driver installation.
3. Close the Win-OS/2 session and all Seamless Windows applications. (Seamless applications are Windows applications that run on top of the PM Desktop.)
4. Open an OS/2 command prompt (windowed or full screen).
5. Insert the CD into the CD-ROM drive.  Type d:\s3trio64\os2.
6. Double click on the OS/2 System icon.
7. Double click on the System Setup icon.
8. Double click on the Display Driver Install icon. 
9. A Display Driver Install dialog appears.
10.When prompted by the Display Driver Install dialog, select Primary Display and click the OK button.
11.Select the S3 Trio 32/64V_ (32 bit) Version option from the Primary Display Adapter Type dialog and select the OK button.
12.Select the appropriate option from the Monitor Configuration/Selection Utility dialog, and click the OK button.
13.The Source Directory dialog appears.
14.Reinsert the diskette in drive A:.
15.Select Install.
   The Installation Program may pause and display prompts to overwrite certain files.
16.Answer YES for each file.
   A shut down message appears.
17.Click the OK button.
18.Remove the driver diskette from the drive.
19.Shut down and reboot system.
   After you reboot, the system comes up using the newly installed driver.